Siemens Sinumerik 840D Operating Turning page 263

Settings
9.1 Selecting the function "Settings"
By pressing the HSK 2.8 "Settings" the following
input mask with the settings for automatic mode is
shown on the screen.
9.2 Vertical softkey bar (VSK)
Display area Description
By pressing the VSK 5 "Changeover inch" the
measuring units are converted from the metric to
the imperial (inch) dimension system. New values
have to be entered in inches. By pressing this key
the key function switches to "Changeover metric".
By pressing the VSK 5 "Changeover metric" the
measuring units are converted from the imperial
(inch) to the metric dimension system. New values
have to be metric. By pressing this key the key
function switches to "Changeover inch".
Accept the selection by pressing the VSK 8 "OK" or
cancel by pressing the VSK 7 "Cancel".
By pressing the VSK 8 "Back" you switch back to
the main screen of the Sinumerik Operate.
9.3 Parameters for "Settings for automatic mode"
In the "Settings for automatic mode" window all configurations for auto-
matic operation can be done.
Parameter Unit
DRY [mm/
min]
840D/828D SINUMERIK Operate
Meaning
Dry run feedrate in mm/min.
Section 9
Notes