Siemens Sinumerik 840D Operating Turning page 437

Simple programming example
4. For the processing, insert a tool into the program.
Press the VSK 1.1 "Select tool".
The tool list window opens.
Place the orange selection cursor on the tool
"ROUGHING_TOOL_A80" by using the blue cursor
keys on the keyboard.
Press the VSK 1.1 "To program" to insert the tool
into the program.
The following program code is inserted into the pro-
gram:
N130 T="ROUGHING_TOOL_A80"
Optionally you can program this line by hand.
5. Program the following G code commands:
N140 M6
N150 S200 M4 F0.4
6. Program now the call up of the contour "CYCLE62".
Note:
The contour itself is programmed at the end of the
program (see section 12).
For this, press the HSK 1.4 "Cont. turn." to open the
technology "Contour turning".
Press now the VSK 1 "Contour".
The vertical softkey bar for creating or calling up a
contour opens.
Press the VSK 2 "Contour call" to open the input
mask for the call up of a contour.
7. Insert the following contour name into the parameter
mask:
Confirm your input by pressing the VSK 8 "Accept".
The following line is inserted into the program:
N160 CYCLE62("BEVEL",1,,)
Note:
The contour "BEVEL" you called up here, will be cre-
ated in section 12.
8. Insert now a stock removal cycle "CYCLE952" into
the program.
Press the VSK 2 "Stock removal" to open the pa-
rameter window for the stock removal cycle.
The following parameter mask for the CYCLE952
opens (see next page).
840D/828D SINUMERIK Operate
Section 2
Notes