Siemens Sinumerik 840D Operating Turning page 502

Hide thumbs Also See for Sinumerik 840D:

Complex measurement example

The key "Hole" is pre-set and is therefore shown in

The input window for the Cycle 977 "Meas. Hole/

CYCLE977" is opened.

Enter the following values into the parameter win-

Acknowledge your entry by pressing the VSK 8

The following lines are added to the program:

_MVAR=101 _SETVAL=50 _PRNUM=1 _KNUM=0

_FA=10 _TSA=10 _VMS=0 _NMSP=1

Enter the following G-Code commands into the pro-

N180 G0 Z-25

Now programme the measuring cycle for measure-

ment of the external diameter of the pipe.

For this press the key "Extension" on the operator

panel to swap to the horizontal softkey-strip 2.

The horizontal softkey-strip 2 is opened.

840D/828D SINUMERIK Operate

Sinumerik 828d