Siemens Sinumerik 840D Operating Turning page 606

Section 3
Notes
B625
B625
Complex programming example
17. As a last step, cutoff of the workpiece.
Press the VSK 5 "Cutoff".
The parameter window for the "Cutoff" cycle opens.
18. Insert the following values into the parameter mask:
To insert a tool into the parameter window, press the
VSK 1 "Select tool".
Mark the desired tool (here PLUNGECUTTER_2) in
the tool list with the orange selection cursor and
press the VSK 1 "To program".
Confirm your inputs by pressing the VSK 8 „Accept".
The following programm block is inserted into the
program:
19. Program now the end of the program and simulate
the machining.
Place the orange selection cursor on the program
block "End of program" and switch to the parameter
mask for the program end by pressing the blue
"cursor-to-the-right" key on the keyboard.
The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value and press the VSK 8
"Accept".
Page 14 840D/828D SINUMERIK Operate