Siemens Sinumerik 840D Operating Turning page 484

Hide thumbs Also See for Sinumerik 840D:

Simple programming example

The following lines will be inserted into the program:

_MVAR=100 _SETVAL=0.5 _MA=1 _FA=10 _TSA=1

_KNUM=1 _PRNUM=1 _VMS=0 _NMSP=1

Program now the end of the program with the follow-

Simulate now the machining of the workpiece.

Switch back to the horizontal softkey bar 1, by press-

ing the "Extend"-key on the operator panel.

Press the HSK 1.7 "Simulation", to start the simula-

tion of the program.

The control calculates the simulation and opens the

simulation window with a view on the side of the

To view the face side of the workpiece during simu-

lation, press the VSK 1.4 "Face view".

840D/828D SINUMERIK Operate

Sinumerik 828d