Siemens Sinumerik 840D Operating Turning page 659

Simple programming example
8. Confirm your inputs by pressing the VSK 8 "OK".
The following two program blocks are inserted into
the work plan.
9. Program the program end and simulate the meas-
urement of the work piece.
Place the orange selection on the program block
"End of program" and extend the line by pressing the
blue "cursor-to-the-right" key on the keyboard.
10. The input mask for the program end opens.
Here, you can decide to repeat the program run.
Accept the default value and press the VSK 8
"Accept".
Switch back to the vertical softkey bar 1 by pressing
the "Extend"-key on the control panel.
The horizontal softkey bar 1 opens.
Press the HSK 1.7 "Simulation" to start the simula-
tion of the program.
The control calculates the simulation and opens the
simulation window in "Top view" by default.
840D/828D SINUMERIK Operate
Section 2
Notes