Siemens Sinumerik 840D Operating Turning page 308

Section 7
Notes
B523
B523
Work offset
7.6 Base zero offset
The defined channel-specific and global base offsets, divided into coarse
and fine offsets, are displayed for all set-up axes in the "Work offset - ba-
sic" window.
7.6.1 Selecting the function "Work offset - basic"
By pressing the VSK 3 "Base" the "Work offset - ba-
sic" window opens.
The horizontal scroll bar above the horizontal softkey bar indicates that
more parameters for the work offset are available. Because of the limited
screen area, they are covered by the softkeys of the vertical softkey bar.
Move the orange selection cursor, with the help of the blue cursor keys on
the keyboard to the left, to reach the additional parameters.
7.6.2 Displaying and editing base zero offset
1. Press the "MENU SELECT"-key on the operator
panel, then the HSK 2 "Parameter" to open the oper-
ating area "Parameter". Alternatively press the
"OFFSET"-key on the keyboard.
2. Press the HSK 5 "Work offset"
3. Press the VSK 3 "Base".
The "Work offset - basic" window opens.
If desired enter values in the white fields of the table
.
Note:
The entered offset values are active directly.
Page 44 840D/828D SINUMERIK Operate