Siemens Sinumerik 840D Operating Turning page 542

Section 5
Notes
B601
B601
Various
5.5.4.2 Parameters for "Offset"
Parameter Description
Offset:
Adds a new offset
New
Adds an Additive off-
Additive
set
Axis:
Offset Z axis
Z
Offset X axis
X
Offset Y axis
Y
5.5.4.3 Setting the offset
1. In the operating area "Program" press the HSK 6
"Various" and the VSK5 "Transformations".
2. Press the VSK 2 "Offset".
3. Optionally change the graphic view on the blank by
pressing the VSK 2 "Graphic view".
4. Select the kind of offset (new, additive).
Enter the offset values for the different axes (Z, X, Y)
in millimeter.
Press the VSK 8 "Accept" to confirm your inputs or
press the VSK 7 "Cancel" to abort.
A new program block "Offset" is inserted into the
program in the editor window (alike the picture be-
low).
Page 34
Help picture/animation
Unit
mm
mm
mm
840D/828D SINUMERIK Operate