Siemens Sinumerik 840D Operating Turning page 281

Tool list
3.5 Additional data
The following tool types require geometry data that is not included in the
tool list display.
Tool type Additional parameters
111 Conical ball Corner radius
head cutter
121 End mill with Corner radius
corner rounding
130 Angle head Geometry length (length X, length Y, length Z)
cutter Wear length (Δlength X, Δlength Y, Δlength Z)
Adapter length (length X, length Y, length Z)
131 Angle head Geometry length (length X, length Y, length Z)
cutter with Corner radius
corner rounding Wear length (Δlength X, Δlength Y, Δlength Z)
Adapter length (length X, length Y, length Z)
140 Face milling External radius
Tool angle
155 Bevel cutter Taper angle
156 Bevel cutter Corner radius
with corner Taper angle
rounding
157 Conical die Taper angle
milling cutter
Note:
You can use the configuration file to specify the data to be displayed for
specific tool types in the "Additional Data" window.
The VSK "Further data" is only available for those tool types which will sup-
port this function .
840D/828D SINUMERIK Operate
Section 3
Notes