Siemens Sinumerik 840D Operating Turning page 307

Work offset
7.5.1 Selection of the function „Work offset - Overview""
By pressing the VSK 2 „Overview" the window
"Work offset - overview" opens..
7.5.2 Parameters for "Work offset - active"
Parameters Meaning
DRF Display of the handwheel axis offset.
Basic reference Display of additional work offset programmed with
$P_SETFRAME. Access to the system offsets is
protected via a keyswitch.
Total base WO Displays all effective basic offsets as well as rota-
tion, scaling and mirroring.
G500 or Display of all work offsets activated with G500, G54 -
G54 - G57 G57, as well as rotation, scaling and mirroring.
You cannot edit these values here.
Transf. reference Displays the work offsets in conjunction with
TRANSMIT and TRACYL
Programmed WO Displays the additional work offset programmed with
$P_PFRAME.
Cycle reference Display of all additional work offsets activated via
$MC_MM_SYSTEM_FRAME_MASK.
Total WO Display of the active work offset, representing the
sum of all work offsets, as well as rotation, scaling
and mirroring.
840D/828D SINUMERIK Operate
Section 7
Notes