Siemens Sinumerik 840D Operating Turning page 616

Section 2
Notes
B633
B633
Simple programming example
11. Fill out the parameter mask as follows:
In order to insert a tool into the parameter mask,
press the VSK 1 "Select tool", mark the appropriate
tool (ROUGHING_TOOL_A80) with the orange se-
lection cursor and press the VSK 1 "To program".
Accept your selection by pressing the VSK 8
"Accept".
The program block "Stock removal" will be inserted
into the work plan:
The program chain is closed.
12. Program now the end of the program and simulate
the machining.
For this, place the orange selection cursor on the
program block "End of program" and switch to the
parameter mask by pressing the blue "cursor to-the-
right" key on the keyboard.
13. The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value by pressing the VSK 8
"Accept.
The program block "End of program" is updated.
Page 8 840D/828D SINUMERIK Operate