Siemens Sinumerik 840D Operating Turning page 571

Simple programming example
3 Confirm your inputs with pressing the VSK 8
"Accept".
The following program block "Program header" will
be inserted into the program.
4. Program now the "Drilling centric" cycle.
For this, press the HSK 1.2 Drill.", to open the func-
tion "Drilling".
Press the VSK 1 "Drilling centric".
The input mask for the "Drilling centric"-cycle opens.
5. Enter the following values into the parameter mask:
To insert a tool into the parameter window, press the
VSK 1 "Select tool", mark the desired tool
(DRILL_D8.5) in the tool list with the orange selec-
tion cursor and press the VSK 1 "To program"
The following program block "Drilling centric" will be
inserted into the program.
6. Program the end of the program and simulate the
machining.
Place the orange selection cursor on the program
block "End of program" and extend the program
block by pressing the blue "cursor-to-the-right"-key
on the keyboard.
7. The settings window for the program end opens,
where you can define to repeat the workpiece.
Accept the default value by pressing the VSK 8
"Accept". The program end is updated.
840D/828D SINUMERIK Operate
Section 2
Notes