Siemens Sinumerik 840D Operating Turning page 639

Hide thumbs Also See for Sinumerik 840D:

Simple programming example

Insert the last "Straight"-cycle into the program.

Press the VSK 2 "Straight" to open the input window

for the function "Straight".

The input window for the function "Straight" opens.

Insert the following values into the parameter mask:

Confirm your inputs by pressing the VSK 8 Accept..

The following program block is inserted into the work

Program now the program end and simulate the

Place the orange selection cursor on the program

block "End of program" and switch to the parameter

mask by pressing the blue "cursor to-the-right" key

on the keyboard.

The input mask for the program end opens.

Here you can adjust whether you want to repeat the

program run or not.

Accept the default value "no" by pressing the VSK 8

To simulate the program run switch back to the hori-

zontal softkey bar 1.

For this, press the "Extend"-key on the operator

The horizontal softkey bar 1 opens.

Press the HSK 1.7 „Simulation".

840D/828D SINUMERIK Operate

Sinumerik 828d