Siemens Sinumerik 840D Operating Turning page 636

Section 2
Notes
B641
B641
Simple programming example
2.2 Programming example: Planar cut
The following ShopTurn program is to be programmed using the technol-
ogy "Straight Circle":
1. Create a new ShopTurn program like described in
the previous section 2.1.
Give the program a name, for example
"ST_STRAIGHT_CIRCLE_1.MPF".
The input window for the program header opens.
2. Enter the following values for the program header
into the input mask and accept your inputs by press-
ing the VSK 8 "Accept".
Page 4 840D/828D SINUMERIK Operate