Siemens Sinumerik 840D Operating Turning page 595

Simple programming example
Description:
A simple turning machining is to be programmed with ShopTurn.
Aim:
A new sequential program is to be created and opened in the editor.
The program header, a stock removal cycle, and the end of the program
are to be programmed.
Afterwards the program is to be simulated.
For this, the following tool- and technology data are to be used:
Tool data: ROUGHING_TOOL_A80
Technology data: F 0.3 mm/rev
V 200 m/min
2.1 Creating a new sequential program
A new ShopTurn program can be created from within the operating modes
"JOG, "MDA" and "AUTO" as follows:
1. Press the "Program Manager"-key on the keyboard.
The program manager will open directly.
- OR -
1. Press the "MENU SELECT"-key on the operator
panel.
Press the yellow HSK 1.4 „Programm manager".
The program manager opens.
2. Select a drive, where you want to create the pro-
gram ("NC", "Local drive", "USB").
3. Press the VSK 2 "New".
The vertical softkey bar for creating new programs
opens.
4. Press the VSK 3 "ShopTurn" to open the input mask
for creating a new ShopTurn sequential program.
Enter a name for the program in the "Name" field
and accept with pressing the VSK 8 "OK".
The program is loaded to the editor and the parame-
ter window for the program header is opened by de-
fault.
840D/828D SINUMERIK Operate
Section 2
Notes