Siemens Sinumerik 840D Operating Turning page 443

Complex programming example
3.1 Programming example: Spigot
The following program is to be created, with the call up of contour descrip-
tions, as well as stock removal- and residual cutting cycles.
Create a new programGUIDE-program in ShopTurn, like described in sec-
tion 2.1 in this module.
Give the program a name, for example „DIN_CONTOUR_2.MPF".
1. Program now the first lines of the program:
N100 G55 G17 G90
N110 G0 X200 Z200
2. Insert a blank for the simulation into the program.
Press the HSK 1.6 "Various" to open the working
area "Various".
Here, press the VSK 1 "Blank" to open the parame-
ter window for the blank.
3. Fill out the parameter mask as follows:
Confirm your inputs by pressing the VSK 8 "Accept".
The following program line will be inserted into the
program:
N120 WORKPIECE(,,"","CYLINDER",192,0,-110,
-100,90)
840D/828D SINUMERIK Operate
Section 3
Notes