Siemens Sinumerik 840D Operating Turning page 290

Hide thumbs Also See for Sinumerik 840D:

3.10.4 Unloading a tool

Either press the "OFFSET"-key on the keyboard or

press "MENU SELECT" on the operator panel, then

the HSK 2 "Parameter" and the HSK 1 "Tool list" to

switch to the tool list.

Place the cursor on the tool that you would like to

unload from the magazine and press the VSK 1.5

Select the required loading point in the "Select load-

ing point" window.

Confirm the selection with pressing the VSK 8 "OK"

or abort with pressing the VSK 7 "Cancel".

3.11 Selecting a magazine

You can directly select the magazine or the NC memory.

Press the VSK 1.7 "Magazine selection".

If there is only one magazine, you will move from

one area to the next (i.e. from the magazine to the

NC memory and from the NC memory back to the

magazine) each time you press the softkey. The cur-

sor is positioned at the beginning of the magazine

If there is more than one magazine, the "Magazine

selection" window opens. Position the cursor on the

desired magazine in this window and press the "Go

to ..." softkey.

The cursor jumps directly to the beginning of the

specified magazine.

Magazines can be hidden in the magazine list.

Uncheck the checkbox alongside the corresponding magazine in the

"Magazine selection" window, by pressing the "SELECT"-key on the key-

The magazine selection behaviour with multiple magazines can be config-

ured in different ways.

Please refer to the machine manufacturer's specifications.

840D/828D SINUMERIK Operate

Sinumerik 828d