Toshiba GL-1010 Administrator's Manual page 137

6 Click
7 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Configuring IPX/SPX Settings
If you are using the IPX/SPX networking protocol for any network traffic
involving the controller, you must enable the IPX/SPX protocol on the
controller. The IPX/SPX protocol is enabled by default. If you are not
using IPX/SPX for any network traffic, disabling the IPX/SPX protocol on
the controller reduces overhead and improves efficiency.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 In the IPX/SPX area, click the
5 Select
6 Click the
7 Select the appropriate setting. The default setting is
8 Click
9 If you change the IPX/SPX protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Configuring TCP/IP Settings
If you are using the TCP/IP networking protocol for any network traffic
involving the controller, you must enable the TCP/IP protocol on the
controller. The TCP/IP protocol is enabled by default. If you are not using
TCP/IP for any network traffic, disabling the TCP/IP protocol on the
controller reduces overhead and improves efficiency.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 In the TCP/IP area, click the
Administrator's Guide
GL-10x0
.
Save
on page 43.
link. The Network page opens.
Network
to enable IPX/SPX. This is the default setting.
Enable
drop-down list.
Frame Type
.
Save
on page 43.
link. The Network page opens.
Network
subtab.
Setup
drop-down list.
Protocol
subtab.
Setup
IP Address Resolution
Rebooting the
.
Auto
Rebooting the
drop-down list.
115