Toshiba GL-1010 Administrator's Manual page 190

6 Select the
or
7 Click
printing mechanism you choose. See
Remote Printer on IPX
When you finish configuring the printer agent, proceed to
Drivers
Note: After you create the printer agent, Wait a minimum of 60
seconds (preferably 90 seconds) before accessing the printer details.
Accessing the details early may result in the display of an incorrect
icon depicting the printer configuration.
Note: If you change the copier configuration after completing the
initial set up and configuration (i.e. you remove the finisher), You
must either reboot the NetWare server or create a new printer agent to
reflect the change configuration.
LPR Printer Agent
If you select the
Remote-LPR Printer Configuration dialog box opens:
TOSHIBA Remote-LPR Printer Configuration Dialog Box
1 Enter the
2 To confirm your choice, click
When the update is complete, proceed to
Configure the controller for LPR/LPD printing to use this service.
(Refer to
168
NDPS Gateway Printing Mechanism
Queue-Based (NDS Printer Agent)
. The configuration dialog box that opens depends on the
Next
on page 171.
LPR Gateway
of the controller and then click
IP Address
LPR/LPD Printing
:
LPR on IP
.
LPR Printer Agent
on page 169, or Queue-Based
configuration option, the TOSHIBA
.
Yes
Select Drivers
on page 175.)
GL-10x0
,
Remote Printer on IPX
on page 168,
on page 170.
Select
.
Finish
on page 171.
Administrator's Guide
,