Printing To The Controller In Unix - Toshiba GL-1010 Administrator's Manual

For example, to change the default orientation to Landscape, add the
following line:
orient= "LANDSCAPE"
To learn the valid options that you can enter in the <queue name>.conf
file:
1 After you install the filter, run the command: find / -name
net_gl10X0.
2 Run the command more <PATH>/net_gl10X0. This file contains all of
the valid options that you can use.
Use these commands as follows:
Locate the command of interest. For example:
nobanner | nb )
banner="none"
The valid option to enter into the <queue name>.conf file is:
banner="none"
With some of the options you have to set more than one parameter. For
example, for booklet printing, locate
booklet=letter | booklet=lt | booklet=LT )
The valid option to enter into the <queue name>.conf file is
The values stored in this file are case sensitive and they must conform to
the /bin/sh variable format.

Printing to the Controller in Unix

LP Command
Use the lp command (lptap in Linux) to send a file to the controller for
printing. The lp command is supported by Solaris, AIX, HP-UX, and
OpenUnix/Sco Unix. This command specifies various printer-specific
options using the -o option parameter on the command line. The lp
command also sets other print options using various other parameters.
Use the man net_gl10X0.1 command to view the online document that
describes the various options and parameters that you can set to
configure printed output.
182
booklet="LT"
booklet_paper="LETTER"
booklet="LT"
booklet_paper="LETTER"
GL-10x0 Administrator's Guide