Peer To Peer Printing - Toshiba GL-1010 Administrator's Manual

Peer to Peer Printing

Considerations and Limitations
You cannot assign the controller to a Microsoft domain; it can
participate only in a Microsoft workgroup.
The controller device name must be unique within the network. The
device name is also required in order to update the controller software
using TopAccess.
Prerequisites
Determine a unique device name (also known as the host name or
Microsoft computer name) for the controller. By default, the device
name is GL<MAC Address>, where <MAC Address> is the media
access control (MAC) number of the NIC installed in the controller.
You can change the device name, providing it is unique within the
network.
Pick a workgroup name for the device or accept the default name,
WORKGROUP
Configuring Microsoft Peer to Peer Printing
1 Launch your web browser. Open TopAccess using the IP address of
the controller you want to configure. (Refer to
page 72.)
Note: You can find the IP address through TopAccessDocMon.
2 Login as an Administrator.
3 Click the Administration tab.
4 Click the Setup submenu.
5 Click the
6 In the Microsoft Printing area, make sure Microsoft printing is
(default).
7 Select
dssc
8 Scroll down to the bottom of the page and click
Proceed to
174
.
Print Services
Disable access to GL_PCL6
to disable access to these print devices.
Installing Client Software
link.
,
Disable access to GL_PS2
on page 229.
GL-10x0
Opening TopAccess
, or
Disable access to
.
Save
Administrator's Guide
on
Enabled