Configuring Wireless Network Protocol Properties - Toshiba GL-1010 Administrator's Manual

6 Enter the
7 Click
8 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Restoring Default Protocol Settings
You can restore the network settings to their default values. Restoring the
defaults returns the controller to the state it was in when it was delivered.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 Click
5 Click
6 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Configuring Wireless Network Protocol
Properties
The
Administration > Setup > Wireless Network
used by client workstations to communicate with the network through
the wireless NIC installed in the controller. You must configure the
wireless protocols before anyone can access the wireless network.
By default, all network protocols are enabled.
You must log in as an administrator to set wireless network protocol
properties.
Note: The Wireless Network page is not available and is not displayed
if the controller does not have a wireless network card installed.
118
AppleTalk Zone
.
Save
on page 43.
link. The Network page opens.
Network
to restore the default settings.
Restore Defaults
.
Yes
on page 43.
string.
Setup
page lets you set up the protocols
GL-10x0
Rebooting the
subtab.
Rebooting the
Administrator's Guide