NEC UNIVERGE SV8100 Features & Specifications Manual page 515

UNIVERGE SV8100
Guide to Feature Programming
Program
Number
11-01-01
11-02-01
11-04-01
11-06-01
11-07-01
11-08-01
11-09-01
11-09-02
11-10-01
11-10-03
11-10-04
Flexible System Numbering
Program Name
System Numbering – Service
Code
Extension Numbering
Virtual Extension Numbering
ACI Extension Numbering
Department Group Pilot
Numbers – Dial
ACI Group Pilot Number
Trunk Access Code
Trunk Access Code – 2nd Trunk
Route Access Code
Service Code Setup (for System
Administrator) – Night Mode
Switching
Service Code Setup (for System
Administrator) – Setting the
System Time
Service Code Setup (for System
Administrator) – Storing
Common Speed Dialing
Numbers
Description/Comments
Customize the system internal
(Intercom) numbering plan.
Assign extension numbers to
extension ports. The telephone
programming identity follows the
port number – not the extension
number.
Assign virtual extension numbers.
Use to define the virtual extension
number to be used for the ACI
extension numbering.
Use to assign pilot numbers to
each Department Group set up
Use to assign the pilot number to
the ACI Groups set in Program
33-02.
If required, change the single-digit
Trunk Access Code (normally 9). If
you change this code, you must
also review the settings in
Program 11-01-01 for the new
code selected.
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Use to customize the night mode
switching Service Codes for the
System Administrator.
Use to customize the system time
Service Codes for the System
Administrator.
Use to store common speed
dialing Service Codes for the
System Administrator.
Issue 5.0
Assigned Data
Refer to Univerge
SV8100 System
Program Manual
Up to eight digits
1 200
2 201
3 202
~ ~
300 499
301 5000
~ ~
512 5211
Up to eight digits
Default not assigned
ACI Ports: 1~96
(default not assigned)
Up to eight digits
(default not assigned)
ACI Groups: 1~16
(default not assigned)
Dial (up to four digits)
(default = 9)
Dial (up to four digits)
[default not assigned)]
MLT,SLT
(default = 818)
MLT
(default = 828)
MLT
(default = 853)
1 - 505