Department Call Forward - NEC UNIVERGE SV8100 Features & Specifications Manual

Hide thumbs Also See for UNIVERGE SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100
Description
Department Group Call Forward allows a user to set call forward for calls routed to a department group.
The forward can be set for each department group and each department group can have its own
destination number that the calls are forwarded to. The destination can be either an internal extension /
pilot number or an off premise number.
The feature will operate for calls via ISDN DDI and internal calls to the pilot number.
The call forward is controlled by service codes and function keys. The destination can also be changed
by the user for each night mode (1-8).
When call forward is set all incoming calls to the department group will be forwarded immediately or after
a delay. Call forward after a delay can only be set via function key 59 (SC 851+59) and will only operate
for incoming DDI calls to the department group.
The destination of the call forward is saved in Abbreviated Dial bin 1999. To route the call off premise
you must enter a trunk access digit (e.g. 9) before the destination number. If there is no trunk access
digit the call will route internally. The internal number can be an extension or another department group
pilot number.
It is also possible to chain the call forwards, for example if department group 01 is forwarded to
department group 02 and group 02 is also forwarded extension 250 then calls to department group 01
will ring at extension 250.
A call that is forwarded off premise will be disconnected after the 'DISA Conversation Warning Tone
Time' and 'DISA Conversation Disconnect Time' in Timers.
The outgoing trunk route is defined by Outgoing Route Setup. A free trunk within this route will be used
when a call is forwarded off premise.
Conditions
Analogue trunks must have disconnect clear enabled when call forward off premise is set,
this is to ensure the lines are cleared when a call is disconnected.
The call forward destination cannot be set from an analogue SLT via Service Code 704.

Department Call Forward

Department Call Forward
Issue 5.0
1 - 355

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents