NEC UNIVERGE SV8100 Features & Specifications Manual page 297

UNIVERGE SV8100
Guide to Feature Programming
Program
Number
14-01-08
15-02-30
20-06-01
20-08-02
20-13-20
21-01-10
Code Restriction
Program Name
Basic Trunk Data Setup – Toll
Restriction
Multiline Telephone Basic Data
Setup – Toll Restriction Class
Class of Service for Extensions
Class of Service Options
(Outgoing Call Service) – Trunk
Outgoing Calls
Class of Service Options
(Supplementary Service) –
Account Code/Toll Restriction
Operator Alert (Restricted
Operation Transfer)
System Options for Outgoing
Calls – Dial Digits for Toll
Restriction Path
Description/Comments
For each trunk, enter 1 to enable
Toll Restriction; enter 0 to disable
Code Restriction.
Select the Toll Restriction Class to
be used when placing a call from a
virtual extension.
Assign a Class of Service (1~15)
to extensions.
Turns Off (0) or On (1) outgoing
trunk calling for the extension.
Turn off or on operator alert when
an extension improperly enters an
Account Code or violates Toll
Restriction.
If this option is programmed with
an entry other than 0, a call does
not have a talk path unless the
user dials at least the number of
digits entered in this option when
placing an outgoing call.
This means that an entry of 4 or
higher in this program causes a
problem when dialing 911. Since it
is only a 3-digit number, the call
does not have a talk path,
preventing the emergency
dispatcher from hearing the caller.
This option should be kept at its
default setting of 0 to prevent any
problem with dialing 911. If the
system detects the call is
answered, by detecting Reversal
in analog trunks, this restores both
– way voice paths immediately.
Issue 5.0
Assigned Data
0 = Restriction
Disabled (No)
1 = Restriction Enabled
(Yes)
(default = 1)
0 = Vir. Ext. (Virtual
Extension Class)
1 = Real Ext. (Real
Extension Class)
(default = 1)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0~24
(default = 0)
1 - 287