NEC UNIVERGE SV8100 Features & Specifications Manual page 491

UNIVERGE SV8100
Program
Number
25-06-01
25-06-02
25-07-02
25-07-03
25-08-01
25-13-01
25-15-01
Embedded VRS
Program Name
VRS/DISA One-Digit Code
Attendant Setup – Next
Attendant Message Number
VRS/DISA One-Digit Code
Attendant Setup – Destination
Number
System Timers for VRS/DISA –
VRS/DISA No Answer Time
System Timers for VRS/DISA –
Disconnect after VRS/DISA
retransfer to IRG
DISA User ID Setup – Password
System Option for DISA – VRS
Message Access Password
DISA Transfer Target Setup –
DISA Transfer Target Area at
Wrong Dial
Description/Comments
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed
to answer outside calls (see
Program 25-02-01), specify the
digit the Automated Attendant
*
#
caller dials (1~9, 0, , ). (Keep in
mind that if you assign
destinations to digits 3 and 4,
outside callers cannot dial system
extensions.)
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed
to answer outside calls (see
Program 25-02-01), specify the
destination reached (four digits
maximum) when the caller dials
the single digit code.
If an Automated Attendant caller
dials an extension that does not
answer, the call waits this interval
before rerouting to the Ring Group
specified in PRG 25-03 and PRG
25-04. This setting also affects
unanswered DISA calls.
Set the timer for disconnecting a
call after it is re-transferred to a
ring group by VRS/DISA.
Set up password (six digits).
Enter the password DISA callers
must dial before the system allows
them to record, listen to or erase
VRS messages.
Used to assign a speed dial
number when the wrong number is
received.
Issue 5.0
Assigned Data
0~100 (0 = No Setting)
101 = Voice MAil
Answers
104 = Refer to 25-04:
VRS/DISA Transfer
Ring Group with No
Answer/ Busy
105 = Dial the other
extension
(default = 0)
106 = record VRS:
record the call to the
embedded VRS
mailbox
Up to eight digits
(default not assigned)
0~64800 (seconds)
(default = 0 seconds)
0~64800 (seconds)
(default = 60 seconds)
Dial (Six digits fixed)
*
#
(0~9, , )
(default not assigned)
*
#
1~ 9, 0, ,
Six digits fixed
(default not assigned)
Speed Dial bin number
0 ~ 1999
(default = 1999)
Version 3 software or
higher is required
1 - 481