NEC UNIVERGE SV8100 Features & Specifications Manual page 180

Issue 5.0
Trunk-to-Trunk Forwarding – Normal (0) Trunks
Program
Number
11-10-06
11-10-07
11-10-08
13-01-01
13-04-01
14-01-26
20-06-01
20-07-05
1 - 170
Program Name
Service Code Setup (for System
Administrator) – Setting the
Automatic Transfer for each
Trunk Line
Service Code Setup (for System
Administrator) – Canceling the
Automatic Transfer for each
Trunk Line
Service Code Setup (for System
Administrator) – Setting the
Destination for Automatic Trunk
Transfer
Speed Dialing Function Setup –
Speed Dialing Auto Outgoing
Call Mode
Speed Dialing Number and Name
– Speed Dialing Data
Basic Trunk Data Setup –
Automatic Trunk-to-Trunk
Transfer Mode
Class of Service for Extensions
Class of Service Options
(Administrator Level) – Set/
Cancel Automatic Trunk-to-
Trunk Transfer
Description/Comments
Customize the service code to be
used to set the Automatic Trunk
Forwarding feature.
Customize the service code to be
used to cancel the Automatic
Trunk Forwarding feature.
Customize the service code to be
used to set the destination for the
Automatic Trunk Forwarding
feature.
Determine if dialing an Speed
Dialing number will dial an outside
number (seizing a trunk as
assigned in Program 13-05) or an
Intercom number (0 = Trunk
Dialing Mode, 1 = Extension
Dialing Mode).
Enter the Common and Group
Speed Dialing numbers and
names which are to be used for
Trunk-to-Trunk Forwarding.
Enable or Disable each trunk the
ability to use Step Transfer.
Assign a Class of Service (1~15)
to extensions.
Turn On (1) or Off (0) the ability of
an extension to use the
Trunk-to-Trunk Forwarding service
codes.
Call Forwarding, Off-Premise
UNIVERGE SV8100
Assigned Data
MLT
(default = 833)
MLT
(default = 834)
MLT
(default = 835)
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing
Mode
(default = 0)
*
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
0 = Normal Transfer
(Normal)
1 = Step Transfer
(Step)
(default = 0)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 0 for
COS 1~15)