NEC UNIVERGE SV8100 Features & Specifications Manual page 429

UNIVERGE SV8100
Program
Number
25-06-01
25-06-02
25-07-01
Direct Inward System Access (DISA)
Program Name
VRS/DISA One-Digit Code
Attendant Setup – Next
Attendant Message Number
VRS/DISA One-Digit Code
Attendant Setup – Destination
Number
System Timers for VRS/DISA –
VRS/DISA Dial Tone Time
Description/Comments
Set up single digit dialing through
the VRS. This gives VRS callers
single-key access to extensions,
the company operator,
Department Calling Groups and
Voice Mail. For each VRS
message set to answer outside
calls (see Program 25-02 and
Program 25-05), you specify:
The digit the VRS caller dials
*
#
(0~9, , ). (Keep in mind that
if you assign destinations to
digits, outside callers cannot
dial system extensions, starting
with that digit.
The destination reached (eight
digits maximum) when the
caller dials the specified digit.
The destination can be an
extension, a Department Calling
pilot number or the Voice Mail
master number. A one-digit code
can be assigned for each
Automated Attendant message.
Set up single digit dialing for
Automated Attendant callers. For
each VRS Message programmed
to answer outside calls, specify:
The digit the Automated
Attendant caller dials (1~12,
*
where 10 = 0, 11 = and 12 =
#
). (Keep in mind that if you
assign destinations to digits
three and four, outside callers
cannot dial system extensions
that begin with that digit.)
The destination reached (four
digits maximum) when the
caller dials the single digit
code.
After answering the DISA trunk,
the system waits this time for the
caller to dial the first digit of the
password. If the caller fails to dial
in this time, the system drops the
call.
Issue 5.0
Assigned Data
0~100 (0 = No Setting)
101 = Voice MAil
Answers
104 = Refer to 25-04:
VRS/DISA Transfer
Ring Group with No
Answer/ Busy
105 = Dial the other
extension
(default = 0)
Up to eight digits
(default not assigned)
0~64800 (seconds)
(default = 10 seconds)
1 - 419