NEC UNIVERGE SV8100 Features & Specifications Manual page 504

Issue 5.0
Guide to Feature Programming
Program
Number
11-12-42
14-02-03
14-02-04
14-04-01
15-03-04
81-10-07
1 - 494
Program Name
Service Code Setup (for Service
Access) – Flash on Trunk Lines
Analog Trunk Data Setup – Flash
Type
Analog Trunk Data Setup –
Hooking Type
Behind PBX Setup
Single Line Telephone Basic
Data Setup – Flashing
COT Initial Data Setup –
Hookflash Time Selection 1
Description/Comments
Use to customize the Service
Codes for flash on trunk lines.
Make sure this item is set for open
loop Flash (0).
For each trunk, indicate if Flash is
for Flash (0) or open loop
disconnect (1).
For each trunk, indicate if the trunk
is installed behind a PBX.
Enables/disables Flash for single
line telephones.
Set the Flash duration (16~4080
ms) for analog trunk CD-4COTB
circuits in Program 81-10-07.
UNIVERGE SV8100
Assigned Data
SLT
(default = 806)
0 = Open Loop Flash
1 = Ground
(default = 0)
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
(default = 0)
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)
2 = Not Used
3 = CTX assume 9
(default = 0)
0 = No
1 = Yes
(default = 1)
0 = 20 ms
1 = 40 ms
2 = 60 ms
3 = 80 ms
4 = 100 ms
5 = 140 ms
6 = 160 ms
7 = 200 ms
8 = 400 ms
9 = 600 ms
10 = 800 ms
11 = 1.0 seconds
12 = 1.5 seconds
13 = 2.0 seconds
14 = 3.0 seconds
15 = 5.0 seconds
[default = 9 (600ms)]
Flash