Mitsubishi Electric GOT2000 Series Hardware User Manual page 139

No. Name
24) Terminating resistor setting switch
25) Emergency stop switch guard cover
installing hole
26) Interface environmental protection
cover
27) Keylock switch (2-position switch)
28) USB interface (Host)
29) USB interface (Device)
30) Reset switch
31) S.MODE switch (OS install switch)
32) SD card access switch
33) SD card access LED
34) SD card interface
35) Ethernet communication status LED
Description
For switching the RS-422/485 communication interface terminating resistor (Set to Disable before
shipping)
Terminating resistor setting
switch enlarged view
ON side
ON
Terminating
resistor
Enable
1 2
Disable
OFF side
Set to "Disable" before shipping
For installing an emergency stop switch guard cover (option)
• GT2506HS-V
Opened and closed to use the USB port, SD card, S.MODE switch, or reset switch.
• GT2505HS-V
Opened and closed to use the USB port or an SD card.
Switch for external direct wiring (independent contact)
For data transfer, data storage (connector type: USB-A)
For PC connection (connector type: USB Mini-B)
Switch for resetting the hardware
Switch used for OS installation at GOT startup.
For enabling or disabling the access to the SD card when the SD card is inserted/removed to/ from the
Handy GOT
ON: SD card access allowed (The SD card cannot be removed.)
OFF: SD card access prohibited (The SD card can be removed.)
ON: SD card installed
Blink: SD card accessed
OFF: SD card not installed or SD card installed but removal possible
For installing an SD card
LED1: ON during data transfer or reception, LED2: ON during 100 Mbps transmission
Switch No.
1 2
ON ON
OFF OFF
4 PART NAMES AND SETTINGS
4
137
4.5 GT25HS-V