Mitsubishi Electric GOT2000 Series Hardware User Manual page 272

No. Name
1) Connector for Handy GOT (42-pin female)
2) Power switch
3) POWER LED
4) Hole for the panel installation
5) Packing attachment chase
6) Hook for DIN rail
7) Hole for the screw installation
8) Terminal block 1
9) Terminal block 2
10) External connection device communication
connector
(RS-232: D-sub 9-pin male)
Connector model name: JES-9P-2A3A (JST)
or equivalent
11) External connection device communication
connector
(RS-422/485: D-sub 9-pin female)
Connector model name: 17JE-13090-37D23A
(DDK) or equivalent
12) External connection device communication
connector
(Ethernet: RJ-45 module jack)
13) Rotary switch (U)
14) Rotary switch (L)
15) ID number valid/invalid selection switch
16) Hole for the flange installation
7 OPTION AND COMMUNICATION CABLE FOR HANDY GOT
270
7.1 Connector Conversion Box
Specifications
Connects the Handy GOT through an external cable.
Supplies the power to the Handy GOT.
When this switch is set to ON, the power is supplied.
Turn off this switch when attaching or removing the Handy GOT.
Lit in green: Power is correctly supplied.
Not lit: Power is not supplied.
Used when mounting the panel.
For M4 screw, depth 6 mm
Used when mounting the panel.
Used for fixing the connector conversion box when mounting DIN rail (35 mm).
Used for fixing on the board, etc.
For M4 screw
Connects the GT16H-CNB-42S, the 24 V DC power supply of Handy GOT, and the emergency stop
switch (ES1 to 3) with M3 terminal screws and the cover.
Connects the operation switch of the Handy GOT (SW1 to 6), the grip switch (DSW-1, 2) and the
keylock switch (KSW-1, 2) with M3 terminal screws and the cover
• GT2506HS-V
For connecting with a controller
(RS-232 connector and RS-422/485 connector cannot be used at the same time.)
• GT2505HS-V
Cannot be used for GT2505HS-V.
For connecting the GT2505HS-V and a connector conversion box via the RS-422 or RS-232
interface, use a connector conversion box (GT11H-CNB-37S).
Page 294 Connector conversion box (GT11H-CNB-37S)
Connects the external connection device via Ethernet with using a LAN cable.
Sets the ID number of GT16-CNB-42S.
Sets one ID number with 14) Rotary switch (L) using both rotary switches (U) and (L).
Enables the recognition function of ID number (ON=Valid, OFF=Invalid).
When connecting the external connection device with using 10) and 11), set OFF (invalid).
Used for fixing the flange when using the connector conversion adapter.