Mitsubishi Electric GOT2000 Series Hardware User Manual page 195

Vertical (For GT2107-W)
B
C
The following table lists the distance required between the GOT and the other devices.
The dimensions within the parentheses apply when no equipment generating radiated noise (such as a contactor) or heat is
installed near the GOT.
Unit: mm (inch)
• For GT2107-W, GT2104-R, GT2104-P, GT2103-P
Item
*2
A
B
C When the SD card is used
When the SD card is not used
D
*1
E
*1 For GT2104-RTBD, GT2104-PMBDS, GT2104-PMBDS2, GT2103-PMBDS, and GT2103-PMBDS2, a distance of 80 mm (3.15 inches)
or more is required to connect an RS-232 cable or personal computer connection cable to the GOT rear face.
When a user-created RS-232 cable is connected to the connector terminal block at the rear face of GT2104-RTBD, a distance of 20 mm
(0.79 inch) or more is required.
*2 For GT2107-W, a distance of 60 mm (2.36 inches) or more is required to connect an RS-485 cable or RS-232 cable.
• For GT2105-Q
Item
A
B
C
D
E When the SD card is used
When the SD card is not used
A
Panel thickness: 1 mm to 4 mm (0.04 to 0.16 inch)
GT21
GT2107-W
GT2104-R
GT2104-P
GT2103-P
50 (1.97) or more [20 (0.79) or more]
50 (1.97) or more [20 (0.79) or more]
50 (1.97) or more
50 (1.97) or more [20 (0.79) or more]
50 (1.97) or more
80 (3.15) or more [20 (0.79) or more]
GT21
GT2105-Q
50 (1.97) or more [20 (0.79) or more]
Horizontal: 80(3.15) or more [20(0.79) or more]
Vertical: 50(1.97) or more [20(0.79) or more]
Horizontal: 50(1.97) or more [20(0.79) or more]
Vertical: 80(3.15) or more [20(0.79) or more]
50 (1.97) or more [20 (0.79) or more]
100 (3.94) or more
100 (3.94) or more [20 (0.79) or more]
E
6 INSTALLATION AND REMOVAL
6.4 Installation Position
6
193