Mitsubishi Electric GOT2000 Series Hardware User Manual page 205

3.
Tighten nuts on the studs in the specified torque range (0.8 N•m to 0.9 N•m) with a wrench for M4 nuts.
Loosen the screws in the slotted holes of the fittings, and adjust the positons of the screws to make the GOT display section
and the control panel surface be in the same plane.
Nut
To attach the environmental protection sheet (sold separately), proceed to step 4.
To attach a user-prepared environmental protection sheet, follow the maunal of the sheet used.
4.
Remove the inner part of the supplied stencil.
Position the stencil on the panel opening, and attach the stencil using backside double-sided tape in four places.
panel
Stencil
Check that the arrow on the stencil points in the direction as shown below.
• For the horizontally-oriented GOT, the arrow on the stencil must point upward.
• For the vertically-oriented GOT, the arrow on the stencil must point leftward.
Stud
Slotted hole
Double-sided tape Double-sided tape Double-sided tape
on the on the on the
back of the stencil back of the stencil back of the stencil
GOT
panel opening
6 INSTALLATION AND REMOVAL
6.6 Installing the GOT
6
203