Mitsubishi Electric GOT2000 Series Hardware User Manual page 175

GT2512F-S, GT2510F-V, GT2508F-V
Open an installation hole on the control panel with the dimensions as shown below.
D
Back of the control panel
Unit: mm (inch)
Model Fitting
installation
position
(on the
GOT)
GT2512F-S Long side of
the GOT
Short side of
the GOT
GT2510F-V Long side of
the GOT
Short side of
the GOT
GT2508F-V Long side of
the GOT
Short side of
the GOT
The C to F dimensions show the measurements for installing fittings on the control panel.
Additionally, install studs on the control panel.
For information on how to install studs, refer to the following.
Page 175 Stud
Horizontal
A F
A B
269(10.59) 214(8.43)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
234(9.21) 187(7.36)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
194(7.64) 158(6.22)
(+2(0.08), 0(0)) (+2(0.08), 0(0))
Vertical
E B
Back of the control panel
C D E
28(1.10) 17(0.67) 36(1.42)
10(0.39) 35(1.38) 18(0.71)
28(1.10) 33(1.30) 32(1.26)
10(0.39) 51(2.01) 14(0.55)
28(1.10) 14(0.55) 32(1.26)
10(0.39) 32(1.26) 14(0.55)
6 INSTALLATION AND REMOVAL
C
F Panel
thickness
26(1.02) 1.5(0.06) to
4(0.16)
44(1.73)
33(1.30)
51(2.01)
29(1.14)
47(1.85)
173
6.2 Panel Cut Dimensions
6