6.15
Installing and Removing the USB cable (GT27,
GT25, GT23, GT2107-W)
The following shows the procedure for installing and removing a USB cable to the USB interface on the GOT rear face.
The locations of the USB interface (Host) and the USB interface (Device) vary by model.
Page 117 PART NAMES AND SETTINGS
Attach a cable clamp depending on the usage environment, such as when fixing a cable is difficult.
Use a cable clamp SKB-132PWD manufactured by SK KOHKI CO., LTD or equivalent.
Installing the USB cable
Install the USB cable to the GOT in the following procedure.
1.
Install the USB cable to a USB interface (Host/device) on the GOT rear face.
2.
Insert a cable clamp to the mounting hole for a cable clamp shown in the following figure and push it until you hear a
clicking sound. For the direction that the band goes through, refer to the arrow in the figure.
3.
Pass the USB cable through a hole of the cable clamp and pull the band to fix the cable.
6 INSTALLATION AND REMOVAL
262
6.15 Installing and Removing the USB cable (GT27, GT25, GT23, GT2107-W)