Installing and removing the panel-mounted USB port extension
Installing and removing the panel-mounted USB port extension to/from the control
panel
Install or remove the panel-mounted USB port extension as follows with attention to the curve or twist of the waterproof cap,
seal, and nut.
Panel thickness
Seal
Install the waterproof cap to the panel-mounted USB port extension so that the control panel surface is IP67F-rated.
Overtightening or undertightening may disable the waterproof effect.
Tighten the waterproof cap properly when the cable is not used.
Panel Cutting Dimensions
GT14-C10EXUSB-4S
Nut
Waterproof
cap
Panel thickness:
2 to 4mm (0.08 to 0.16inch)
Specified torque range:
0.30 to 0.34N ・ m
6.16 Installing and Removing the Panel-Mounted USB Port Extension
GT10-C10EXUSB-5S
19.4±0.1
(0.77±0.01)
Panel thickness:
1.6 to 2mm (0.06 to 0.08inch)
Specified torque range:
0.28 to 0.32N ・ m
6 INSTALLATION AND REMOVAL
6
14.8±0.1
(0.58±0.01)
265