Installing The Got; Gt27, Gt25, Gt23 - Mitsubishi Electric GOT2000 Series Hardware User Manual
Graphic operation terminal
Hide thumbs
Also See for GOT2000 Series:
- Connection manual (1224 pages) ,
- User manual (654 pages) ,
- Basic training textbook (255 pages)
Table of Contents
Advertisement
6.6
Installing the GOT
Install the GOT in the following procedure.
For the panel cut dimensions for the GOT, refer to the following.
Page 168 Panel Cut Dimensions
GT27, GT25, GT23
The following shows an installation example for the horizontal direction.
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points upward.
Page 117 PART NAMES AND SETTINGS
GT27, GT2512-S, GT2510-WX, GT2510-V, GT2508-V, GT2507-W, GT2507T-W, GT23
1.
Insert the GOT rear face into the panel opening.
GOT
2.
While positioning a fitting on the mounting hole of the GOT, tighten a screw within the specified torque range (0.36 N·m
to 0.48 N·m).
Tightening the screw with a torque exceeding the specified torque range may deform the GOT front panel, causing the
protective sheet to become crinkled.
For GT2715-X (8 fittings)
6 INSTALLATION AND REMOVAL
200
6.6 Installing the GOT
Panel opening
Advertisement
Table of Contents
Troubleshooting
