Emergency Stop Switch Guard Cover; Applicable Emergency Stop Sw Guard Cover; Installing Procedure - Mitsubishi Electric GOT2000 Series Hardware User Manual

7.2

Emergency Stop Switch Guard Cover

The emergency stop SW guard cover is attached to prevent the emergency stop SW from being operated incorrectly.

Applicable emergency stop SW guard cover

The following emergency stop SW guard cover is applicable for the Handy GOT.
○: Usable, -: Not usable
Product name
Emergency stop SW guard cover

Installing procedure

1.
Remove the Handy GOT from the device or turn the entire system power off.
Make sure that operating the emergency stop switch of the Handy GOT does not affect the system during the installation of
the emergency stop SW guard cover.
2.
Align the installation hole of the emergency stop switch guard cover with the relevant installation hole on the Handy GOT.
Tighten the supplied screws (M3×6) within the specified torque range (0.36 N•m to 0.48 N•m) to fix the cover.
Too much tightening may cause damage.
Example) GT2506HS-V
7 OPTION AND COMMUNICATION CABLE FOR HANDY GOT
300
7.2 Emergency Stop Switch Guard Cover
Model name Contents
GT16H-60ESCOV Mounting screw (M3 × 6) ×1 (accessory)
GT14H-50ESCOV
GT2506HS-V GT2505HS-V
○ —
— ○