3.
To replace the battery, remove the old battery, and then disconnect the connector.
For information on how to remove the battery, refer to the following.
Page 237 Removing the Battery
4.
Insert the battery connector to the GOT connector.
Connector
Battery
5.
After installing the battery to the battery holder of the GOT, close the SD card cover until it clicks.
Battery
Connector
6.
Turn on the GOT.
7.
Check that the battery condition is normal with the utility.
For the details of the battery condition display, refer to the following.
GOT2000 Series User's Manual (Utility)
SD card cover
Black cable
Red cable
SD card cover
6 INSTALLATION AND REMOVAL
6.10 Installing the Battery
6
229