Installing And Removing The Usb Devices (Gt27, Gt25, Gt23, Gt2107-W); Installing The Usb Devices - Mitsubishi Electric GOT2000 Series Hardware User Manual

6.14
Installing and Removing the USB Devices (GT27,
GT25, GT23, GT2107-W)
The following shows the procedure for installing and removing a USB device.
Connecting the USB hub devices to the USB interface (Host)
When connecting the devices to the USB interface (Host) using USB hub with the GOT power on, drive
assignment of connected USB devices may be changed.To use the USB hub devices, turn on the GOT with
the devices connected.

Installing the USB devices

For GT27 and GT25 equipped with the USB interface (Host) on the front face
1.
Push the [PUSH] mark on the USB environmental protection cover to open the cover.
2.
Insert the USB device to the USB interface (Host) as shown below.
Make sure to insert the USB interface connector in the correct direction.
For GT27, GT25, GT23, and GT2107-W equipped with the USB interface (Host) on the
rear face
1.
Insert the USB device to the USB interface (Host) as shown below.
Make sure to insert the USB interface connector in the correct direction.
6 INSTALLATION AND REMOVAL
260

6.14 Installing and Removing the USB Devices (GT27, GT25, GT23, GT2107-W)