Mitsubishi Electric GOT2000 Series Hardware User Manual page 309

Selection of the RS-232 connection, RS-422 connection, or Ethernet connection
GT2505HS-V can be connected to a controller using the RS-232, RS-422, or Ethernet connection.
Select the RS-232 connection, RS-422 connection, or Ethernet connection by using the cable connector for the PLC
communication in the environmental protection back cover.
• For the RS-232 connection, connect the cable connector for PLC communication to RS-232 connector.
• For the RS-422 connection, connect the PLC communication cable connector with the RS-422 connector.
• For the Ethernet connection, connect the PLC communication cable connector with the Ethernet connector.
The Ethernet connection is selected at factory shipment.
The selected connection method (RS-232 connection or RS-422 connection) at the Ethernet connection is applied when the
Handy GOT power is turned on.
The connector can be checked through the window when the environmental protection back cover is closed.
It can be used as a method to check the connection type from the outside of the Handy GOT.
The available connection type differs depending on the external cable to be used.
• GT14H-C□□-42P: Ethernet connection
• GT11H-C□□-37P: RS-232, RS-422, and Ethernet connection
• GT11H-C□□: RS-232 connection and RS-422 connection
■Precautions for switching among the RS-232, RS-422, and Ethernet connections
Before connecting or disconnecting the cable connector for PLC communication, make sure to turn off the Handy GOT.
Not doing so may cause a failure.
Environmental protection back cover opened
Environmental protection
back cover window
7 OPTION AND COMMUNICATION CABLE FOR HANDY GOT
Cable connector
for PLC communication
7.4 Overview of Communication Cable
7
307