Mitsubishi Electric GOT2000 Series Hardware User Manual page 299

■Installation with the mounting bracket
1.
Open installation holes on the panel with the dimensions shown below.
+0.5
(0.16 )
Drill 3-Φ4
0
Unit: mm (inch)
2.
Install the supplied mounting bracket on the connector conversion box.
Tighten the screws within the specified torque range (0.49 N•m to 0.68 N•m).
Overtightening the screws may cause damage.
Mounting bracket (accessory)
Mounting screw (accessory)
M3 × 3
3.
Install the connector conversion box on the panel.
Overtightening the screws may cause damage.
Tighten the screws within the specified torque range (0.69 N•m to 0.88 N•m).
M4 screw and nut x 3 sets
(prepared by user)
+0.02
0
Connector conversion box
3-Φ4.5(0.18)
Mounting bracket
7 OPTION AND COMMUNICATION CABLE FOR HANDY GOT
10(0.39)
20(0.79)
Unit: mm (inch)
7.1 Connector Conversion Box
7
297