Installing a relay cable connector (GT2505HS-V only)
■Configuration
The following shows the configuration for using the GOT connected to the connector that is attached on a control panel or
operation panel.
Handy GOT
1)
Name
1)
External cable
(Relay cable connection side D-Sub 37pin)
2)
Relay cable for connecting to a PLC
*1 Use C or later version.
Select the cable according to the communication method and controller
For the cable selection, refer to the following.
GOT2000 Series Handy GOT Connection Manual For GT Works3 Version1
If a relay cable other than the above is required, create the cable by yourself.
To use a cable with loose wires at one end for external connection (GT11H-C30, GT11H-C60, or GT11H-C100), refer to the
following and select one according to the application.
GOT2000 Series Handy GOT Connection Manual For GT Works3 Version1
Control panel or
operation panel
2)
PLC
For panel cutting dimensions,
refer to the following page.
Description
*1
GT11H-C30-37P
*1
GT11H-C60-37P
*1
GT11H-C100-37P
*1
GT11H-C15R4-8P
*1
GT11H-C15R4-25P
*1
GT11H-C15R2-6P
6 INSTALLATION AND REMOVAL
6.8 Handling the Handy GOT
6
221