Table 1-29 Incoming Ringing Tone - NEC SL1000 Features And Specifications Manual

SL1000
Program
Number
82-01-01
Incoming Ring
Tone Number
Pattern 1
(Trunk Incoming)
Pattern 2 (Trunk
I
Incoming)
Pattern 3
(Trunk Incoming)
Pattern 4
(Trunk Incoming)
Intercom Incoming
Pattern
Alarm Sensor Pattern
Operation
To place an Intercom call:
1. At multiline terminal, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial extension number (or 0 for your operator).
Your call may voice-announce or ring the called extension. Dial 1 to change the way your call alerts the
called extension.
If the extension you call is busy or does not answer, you can dial another extension without hanging up.
To answer an Intercom call:
1. If you hear two beeps, speak toward telephone.
Your telephone picks up your voice.
- OR -
If your telephone rings, lift the handset.
To check the extension data (multiline terminal only):
1. Press the Help key.
2. Dial the extension number.
You display shows your telephone extension number, port number and extension/Department Group.
1-296
Program Name
Incoming Ring Tone - Frequency 1

Table 1-29 Incoming Ringing Tone

Tone
Frequency 1
Type
High 1100
Mid 660
Low 520
High 1100
Mid 660
Low 520
High 2000
Mid 1400
Low 1100
High 2000
Mid 1400
Low 1100
High 1100
Mid 660
Low 520
High 760
Mid 760
Low 760
Refer to Table 1-29 Incoming Ringing
Tone on this page
Frequency 2
1400 16Hz Modulation 16Hz
760 Modulation 16Hz
660 Modulation
1400 8Hz Modulation 8Hz
760 Modulation 8Hz
660 Modulation
760 16Hz Modulation 16Hz
660 Modulation 16Hz
540 Modulation
760 8Hz Modulation 8Hz
660 Modulation 8Hz
540 Modulation
1400 8Hz Modulation 8Hz
760 Modulation 8Hz
660 Modulation
760 No Charge
760 No Charge
760 No Charge
ISSUE 1.0
Default
Modulation
Intercom