NEC SL1000 Features And Specifications Manual page 323

ISSUE 1.0
Program Number
26-05-03 Authorization table number
26-05-04 Cost Centre Code
26-06-01 Authorization Code Table
26-07-01 Cost Centre Codes
26-08-01 Manual Override Access Code Table
26-09-01 Manual Override Exemption Table
Note 1) Change to DTMF Operation
In Program 26-05-02 the @ symbol will have different operation for Analogue trunks or ISDN trunks.
Analogue Trunks
At the point in the dialled digits where the @ appears the SL1000 will revert to DTMF dialling. This is only required when the
analogue trunk is set the Loop Disconnect dialling in Program 14-02-01.
ISDN Trunks
At the point in the dialled digits where the @ appears the SL1000 will stop dialling and wait for the CONNECT from the indirect
carrier. The SL1000 will then continue to dial DTMF in the B-channel. The DTMF digits will be received by the indirect carrier
for routing.
This is only required for indirect carriers that have a two stage setup process where the Access code is dialled in the
D-channel to the direct carrier and all other digits are dialled as DTMF in the B-channel to the indirect carrier.
Note 2) Order of LCR Routing Digits
When a user dials a number that is routed by LCR the individual LCR elements will be dialled to line as shown below.
<Access Code> <Authorisation Code> <CCC> <Delete leading digits> <Dialled digits>
Features and Specifications Manual
Program Name
SL1000
Default
0
0
No Setting
No Setting
No Setting
999
L
1-315