NEC SL1000 Features And Specifications Manual page 577

ISSUE 1.0
To program a key, press Speaker, dial 851
Use this key... For this feature...
Code: 27 Speed Dialing
Operation: Press
key + bin + Line or
Speaker key
Code: 28
Operation: Press
key + bin + Line or
Speaker key
Code: 29 Repeat Redial
Operation:Place
call + Press key
Code: 30 Save Number
Operation: Dialed
Save: Place call +
Press key
Redial: Line or
Speaker key +
Press key
Code: 31 Memo Dial
Operation:
Store: While on
call, Press key +
number to store
Use: Press key +
Speaker key or
line
Erase: Speaker
key + Press key
Code: 33 Off-Hook Signaling
Operation: Call
ext. and receive
busy + Press key
Code: 34 Barge-In
Operation: Call
ext + Press key
Code: 35 Callback / Camp-On
Operation: Call / Trunk Queuing
busy extension or
access busy trunk
+ Press key
Code: 36 Department Step
Operation: Dial Calling
busy ext + Press
key
+ pswd
(0000) + place
outside call
Code: 37 Call Forwarding / Do
Operation: Call Not Disturb Override
extension + Press
key
Code: 38 Message Waiting
Operation: Leave
message: Call ext
+ Press key OR
Answer message:
Press key
Code: 39 Room Monitor
Operation: Press
key at destination
and source + ext
Features and Specifications Manual
(for 2-digit codes) or 852 (for 3-digit codes), press the key and enter
the code (e.g., 48 for Voice Over).
When you ... Key Lamp Status
Dial a stored None
System Speed
Dialing number.
Dial a stored Group None
Speed Dialing
number.
Activate repeat Fast Flash while
redial while on a system waits to redial
call.
Save, redial or None
check a saved
number.
Store, use or check None
a Memo Dial
number.
Signal a busy None
extension.
Barge-In on a None
co-worker's conver-
sation.
Leave a Callback On red when acti-
request at a busy vated
extension, Camping
On to a busy exten-
sion, or Queue for a
busy trunk.
Step Call through a None
Department Group
for an idle member.
Override an exten- On red when acti-
sion Call vated
Forwarding or Do
Not Disturb.
Answer/Leave a None
Message Waiting.
Activate Room Fast Flash red at
Monitor. destination, Hold
Flash red at source
SL1000
Also see Srvc Note
Code
#2 + bin
#4 + bin
-
815
-
809
810
850
808
807
0
*
or
0
-
2-19