Table 1-30 Restrictions For Calling Party Names - NEC SL1000 Features And Specifications Manual

ISSUE 1.0
+ 2D) . The T1/PRI Interface uses a single slot. When installed, the T1/PRI Interface uses the first
block of 32 consecutive trunks.
• When using fractional PRI, the unit comes up as zero ports until program 10-03-06 is set to the 4/8/
12/16/20/24(auto), and then reset.
• If fractional PRI has the number of ports changed, the Trunk Port number might change if they be-
come split or fit into an empty gap of trunk ports.
• If using a CSU/DSU, Program 10-03-13 must be set to 0. If not using a CSU/DSU, Program 10-03-13
must be set to 1~7 or anything other than 0.
• Restrictions for Calling Party Name:
The SL1000 supports receiving the name from the Network in supported formats only and cannot
send the Calling Name. Refer to
P o r o t c o s l
I N 2 -
4 E S S A ( T & T C u s o t m )
A T & T 5 E S S L u c e t n C u s o t m
D M S 1 - 0 0 ( C u s o t m * )
DMS-100 (National; ISDN) **
* Nortel Specification NIX-A211-1
** Nortel Specification NIS-A233-1
• CO Line Service is not supported.
ISDN - PRI cannot be configured for CO Emulation
• B-Channel to Trunk Association
When an Incoming ISDN-BRI/PRI call is received, the system assigns the lowest trunk number of the
ISDN circuit to the incoming call associated with the B-Channel. When an Outgoing call is placed
using the ISDN-PRI/BRI, the system assigns the Trunk and B-Channel association according to the
chart below. This is based on the Trunk-to-Trunk Group and Trunk Group Priority assignment in (Pro-
gram 14-05-01).
Features and Specifications Manual
Table 1-30 Restrictions for Calling Party Names on this

Table 1-30 Restrictions for Calling Party Names

F a l i c y t i I f n r o
N t o S u p p r o e t
F a l i c y t i I f n r o
D s i p a l y I f n r o
Facility Information Element **
N a m e D l e v i e y r F r o
m t a o i n E e l m e n s t
d
m t a o i n E e l m e t n
m t a o i n E e l m e n * t
SL1000
page.
m a s t
1-299
I