NEC SL1000 Features And Specifications Manual page 507

ISSUE 1.0
To enable this feature, the system has a program option, Program 11-15-09: Service Code Setup
Administrative (for Special Access) - Transfer to Trunk Ring Group Code (not assigned at default).
When a call is transferred using this service code, it is transferred to the ring group destination for that
incoming trunk. For example, trunk 2 is in Ring Group 4. When the call is transferred using this service
code, the trunk rings all extensions programmed for Ring Group 4 or rings the External Paging Group
for Ring Group 4, depending on how the system is programmed.
Program 22-04-01: Extension Ring Group Assignment and Program 22-05-01: Incoming Trunk Ring
Group Assignment must be programmed to allow an extension access to the ring groups. If the call is
not answered, it can overflow to the destination defined in Program 22-08-01: DIL/IRG No Answer
Destination.
This service code can also be used with the VRS. This provides the caller listening to the VRS
message with the ability to transfer their call and have it ring the external page. The code the caller
would dial is defined in Program 25-06-02: VRS/DISA One-Digit Code Attendant Setup.
Transfer Key Can Place Call on Hold
While on a call, and the Transfer key is pressed, the call is placed on hold.
Conditions
• An existing call can be transferred into a call with Barge-In enabled.
• Unscreened Transfers from voice mail show pre-answer Caller ID information.
• With Transfer to Busy Extensions enabled (Program 24-02-01 = 1), Call Forwarding with Both Ring-
ing offers a unique option. A transferred call waits for either the forwarding or destination extension to
become free. The call goes through to the extension that first becomes available. If neither extension
becomes free in the Transfer Recall Time, the call recalls the transferring extension.
With Transfer to Busy Extensions disabled (Program 24-02-02 = 0), you must also set Program 20-09-07 for
the extensions COS to 0 to disable call queuing and Program 20-13-06 to set Automatic Off-hook Signaling
to manual.
• An existing call can be transferred into a conference call.
• Meet Me Paging Transfer allows the user to page a co-worker and have the call automatically trans-
ferred when the co-worker answers the page.
• When transferring, an extension user can press a One-Touch key instead of dialing the extension
number.
• Serial calls allow for transferring a call so it automatically returns to the transferring extension when
completed.
• When a multiline terminal user is on a call, they can transfer to another station by pressing a DSS
key for that station. It is not necessary to press Transfer to transfer to another station with a DSS key.
When a multiline terminal user is on a call, they must press transfer to transfer a call off site with a DSS key.
• The following features require certain tones be changed in Program 80-01-02. Refer to the table in
the InMail feature programming section for settings:
- Call Holding
- Busy Greeting
- Call Screening
- Await Answer Transfer
• A Trunk-to-Trunk transfer can be established by the following operation:
1. While talking to an outside party, press Hold.
2. Access a second outside line and dial the desired number.
3. Press Transfer to complete the Trunk-to-Trunk transfer.
When the second call is to be transferred to another station (Not Trunk-to-Trunk), the user should press
Hold at step 3, then dial the desired station and press Transfer to complete the transfer.
• If station A calls Station B, and station A puts station B on hold and then calls station C, station C
cannot transfer the call.
Features and Specifications Manual
SL1000
T
1-499