Connecting Ivs1800 Cables - Huawei FusionModule500 User Manual

FusionModule500 Smart Mini Data Center
User Manual
Step 2 Connect one end of the network cable to any GE network port on the VCN.
Figure 4-116 Ports on the VCN
(1) Ground terminal
(4) Power button
Step 3 Connect one end of the power cable to the input power port on the power module
and the other end to the PDU2000 in the cabinet.
----End

4.3.4.4 Connecting IVS1800 Cables

Prerequisites
Cables have been prepared.
Procedure
Step 1 Connect one end of the ground cable to the ground terminal on the device and
the other end to the ground point on the cabinet. A Phillips screwdriver and M4
screws are required.
The customer needs to prepare the ground cable.
Step 2 Connect one end of the network cable to any GE network port on the IVS.
Figure 4-117 IVS Rear panel
Issue 02 (2020-12-25)
NO TE
After connecting the power cable, turn on the power switch on the panel to start the
device.
NO TE
Copyright © Huawei Technologies Co., Ltd.
(2) GE1 port
(5) Power port
4 Installation Guide
(3) GE2 port
148