Huawei FusionModule500 User Manual page 49

FusionModule500 Smart Mini Data Center
User Manual
Indica
tor
ALM
RF_Z
SW Button
Table 3-23 SW button description
Function
Description
Wireless
network RF_Z
(802.15.4)
pairing
Issue 02 (2020-12-25)
Color Name
Red Alarm indicator
Green Communication
status indicator
Operation Description
In non-wireless network (802.15.4)
pairing mode, press and hold down
the button for 3s to 5s to enter the
wireless network pairing mode.
In wireless network (802.15.4)
pairing mode, press and hold down
the button for 3s to 5s to exit the
pairing mode; or the system
automatically exits the pairing mode
after 30 minutes without pressing
the button.
Copyright © Huawei Technologies Co., Ltd.
Status Description
Blinking at The software runs properly
long (the indicator blinks at 0.5
intervals Hz, on for 1s and then off
for 1s) or the ECC800-Pro
registers with the NetEco
successfully.
Blinking at The ECC800-Pro does not
short register with the NetEco
intervals (the indicator blinks at 5 Hz,
on for 0.125s and then off
for 0.125s).
Steady on A system failure alarm is
generated.
Off The system is normal.
Blinking at A network is set up, and no
long node access is allowed (the
intervals indicator blinks at 0.5 Hz, on
for 1s and then off for 1s).
Blinking at A network is set up, and
super node access is allowed (the
short indicator blinks at 10 Hz, on
intervals for 0.05s and then off for
0.05s).
Indicator Status
The RF_Z indicator is
blinking at super
short intervals.
The RF_Z indicator is
blinking at long
intervals.
3 System Architecture
39